HP Surestore Tape Library Model 2/20 User Manual page 126

Table 18
Library Status
Slave card failed
Fibre Channel
controller failed
Front Panel
Front panel not
present
Front panel failed
Miscellaneous
Date and time not
set
Door open
124 Understanding Error States
Partial Availability Conditions
Cause
Library slave controller card failed
power-up test.
Note: Slave controller cards are
required in all but the lowest level of
the library.
Fibre Channel controller failed
power-up test. (Usually due to
problems on the SCSI bus, such as
an LVDS drive or terminator on an
HVDS bus, etc.)
Library could not detect the front
panel display.
Front panel display failed power-up
test.
The date and time is not set on the
front panel
One or more tape doors are open.
The library robotics will not move
until the door is closed.
Solution
Verify that a slave card is present
in all but the lowest level of the
library.
Verify that the cards are properly
seated.
Power cycle the library.
Contact your service
representative.
Verify that proper SCSI
terminators and/or tape drives
are attached to the Fibre Channel
controller.
Verify that there are no bent pins
on the controller.
Power cycle the library.
Contact your service
representative.
Power cycle the library.
Contact your service
representative.
Power cycle the library
Contact your service
representative.
Set the date and time. (See
the Date and Time on page 108.)
Ensure that doors are closed.
Setting
Chapter 4