HP Surestore Tape Library Model 2/20 User Manual page 97

Chapter 3
Note When you reconfigure the library, you may also need to
reconfigure your backup software. For more information, consult
the documentation provided with your software.
Main Menu -> Administration -> Change Configuration -> Mailslot
Before changing the mailslot configuration, verify the slots that
Note
will become the mailslot are empty and not the original location
of a tape in a drive.
Use the following steps to configure the mailslot option.
1. In the
Configure Mailslot
storage slot and mailslot configurations in the backup software.
Select .
[OK]
2. The next screen will describe the prerequisites for configuring the mailslot.
Verify these prerequisites have been met, then select
3. The display will indicate the current mailslot setting. Select the number of
mailslots desired (0 slots, 1 slot, 1 magazine, or 2 magazines). See
13 on page 94 for information about each option.
A confirmation screen automatically displays the success or failure of the
change and reminds you to reconfigure the backup software.
4. Select to exit.
[Done]
Do not change the mailslot setting without reconfiguring your
Caution
backup software. The backup software must reflect the mailslot
setting to assist in tracking tape exchanges and the current
location of all tapes. Verify that your backup software supports
and reflects the mailslot configuration that you select.
menu, a message will remind you to check the
Configuring the Library
.
[OK]
Table
95