Configuring The Library For Fibre Channel; Configuration - HP Surestore Tape Library Model 2/20 User Manual

Hp surestore tape library user's guide
Hide thumbs Also See for Surestore Tape Library Model 2/20:
Table of Contents

Advertisement

Configuring the Library for Fibre Channel

Configuration

102 Configuring the Library for Fibre Channel

Note
When you reconfigure the library, you may also need to
reconfigure your backup software. For more information, consult
the documentation provided with your software.
The optional Fibre Channel controllers in the library serve as a bridge between
SCSI and Fibre Channel.
Note
It is not necessary to connect the library to its Fibre Channel
topology (arbitrated loop or fabric) before configuration.
Note
When Fibre Channel controllers are installed in the library,
device SCSI IDs cannot be changed from their factory default.
Though you do not need to set SCSI IDs for Fibre Channel, you will need to
configure Fibre Channel addressing.
Main Menu -> Administration -> Change Configuration -> Fibre Channel
1. Enter the
Fibre Channel
2. Select the level where the Fibre Channel controller you want to configure is
located.
Use the
key to select a lower level in the library.
[-]
Use the
key to select a higher level in the library.
[+]
Select
if the level is correct.
[OK]
3. A message displays the following information:
— Fibre Channel controller type (LVD or HVD SCSI)
— SCSI bus status
Select
.
[MORE]
menu.
Chapter 3

Advertisement

Table of Contents
loading

Table of Contents