Removing And Replacing Cards; Removing A Card - HP Surestore Tape Library Model 2/20 User Manual

Hp surestore tape library user's guide
Hide thumbs Also See for Surestore Tape Library Model 2/20:
Table of Contents

Advertisement

Removing and Replacing Cards

Removing a Card

160 Removing and Replacing Cards

Caution
This library contains very sensitive electrical components. It is
important to follow the proper procedures to prevent electrostatic
discharge (ESD). Use wrist-grounding straps and anti-static mats
when removing and replacing cards and major assemblies.
Failure to follow proper procedures could lead to intermittent
failures or premature hard failures.
Caution
The Fibre Channel printed circuit boards may contain a laser
system (GBIC or GLM module) that is classified as a "Class-I
Laser Product" under a U.S. Department of Health and Human
Services (DHHS) Radiation Performance standard according to
the Radiation Control for Health and Safety Act of 1968 and
EN60825-1(+A11) safety of laser products. The compliance
statement is located on the module.
Before powering the library off to remove a card, review the LEDs on the back
of each card to ensure there is no activity (see
page 130).
1. Note the library configuration settings (if you will be downloading new
firmware), and power off the library.
2. Note how the library is connected and the placement of the card, and
then remove all external cables attached to the card.
3. Loosen the two thumbscrews on the card by hand or with a screwdriver.
4. Remove the card by gently pulling it outward.
Interpreting Library LEDs
Chapter 5
on

Advertisement

Table of Contents
loading

Table of Contents