HP Surestore Tape Library Model 2/20 User Manual page 59

Chapter 1
8. Extend the rack's anti-tip foot.
Failure to extend the anti-tip foot could result in personal injury
WARNING
or damage to the library.
9. Open the magazine drawers and loosen the screws that lock the library
into place (Figure 14
trim brackets.
10. Remove the stop bracket. (See
page 26.)
11. Push the library out of the rack until it hits the latch stops (approximately
2/3 of the library is out of the rack).
12. Reattach the lifting straps to the sides of the library.
13. Release the library from the rack.
4/40 and 6/60 Series Libraries:
Depress the latch stops at the top of the library with a screwdriver or
similar tool (Figure 26
2/20 Series Libraries:
If the library does not have enough clearance above for a tool to be
inserted, unscrew the four screws (two on each side) from the top (black)
mounting rail on the front of the library. Pull the library partially out, then
lower the front half of the library to ease it under the latch stops.
Once you have loosened the mounting screws, the library is no
WARNING
longer secured inside the rack and can cause bodily harm and/
or damage to the library if it is dropped.
on page 30). The screws are located in front of the
on page 25 and
Figure 9
on page 58).
Moving or Shipping the Library
on
Figure 10
57