HP Surestore Tape Library Model 2/20 User Manual page 26

Figure 8
24 Installing the 2/20, 4/40 & 6/60 Series Libraries into a Rack
4/40 and 6/60 Series Libraries:
Use a mechanical lift that is rated to the weight of the library, and follow
the steps below to install the library.
a. Break away the edges of the packing material at the bottom of the
library.
b. Use the straps to ease the library onto an appropriately rated
mechanical lift. Use the lift to raise the library so that it aligns with the
bottom rails.
c. Slide the library onto the lower rails. Have at least one person guide
the library from the front and one person pull the library from the
back, using the vertical handle
d. Remove the lifting straps once the library is partially installed. Save
the straps for future use when moving the library.
Library Installation
Do not push the library from the front. Use the handle shown in
Caution
8. DO NOT pull on the handle(s) located on the back of
Figure
the power supply or drive modules.
(Figure 8 on page 24).
Chapter 1