HP Surestore Tape Library Model 2/20 User Manual page 217

Hp surestore tape library user's guide
Hide thumbs Also See for Surestore Tape Library Model 2/20:
Table of Contents

Advertisement

Table 46
Decimal
Hex
Error
Error
72
48H
74
4AH
75
4BH
76
4CH
77
4DH
78
4EH
80
50H
81
51H
Appendix
Error Codes and Recovery Procedures
Description
Unable to put tape
back into slot after
power cycle.
Drive module
disconnected or has
failed.
Drive(s) fan
disconnected or
faulty.
Failed to perform an
inventory check.
Transport moved
above highest
detected level.
Not all drives in the
library are the same
type.
Drive reports
hardware error.
Library failed during
initialization.
Recovery Method
Note the error code qualifier to help determine
appropriate testing.
Ensure that all drive modules are fully inserted
into the drive bays at the rear of the library.
Note the LEDs on the drive modules. See
Interpreting Library LEDs
understand what the LEDs may indicate.
If the LED indicates failure, replace the drive
module.
Note the error code qualifier to help determine
appropriate testing.
Note the error code qualifier to help determine
appropriate testing.
Run the
Test Vertical Motion
Library Diagnostic Tests
Check to ensure that you have the correct type of
drive.
Power cycle the library and re-try.
Replace the drive module if unsuccessful. See
Removing and Replacing Drive Modules
page 162.
Power cycle the library.
on page 130 to
test (see
Running
on page 156).
on
Library Error Codes 215

Advertisement

Table of Contents
loading

Table of Contents