Running Library Diagnostic Tests - HP Surestore Tape Library Model 2/20 User Manual

Running Library Diagnostic Tests

Table 28
156 Diagnostic Support Tools
Main Menu -> Administration -> Run Test
Use the following procedure to run internal tests of library functions.
on page 156 describes these tests.
1. From
Administration
options. Select
[Run Test]
2. From , use the
Run Test
3. Select to select the test.
[OK]
4. Select the number of times this test will run.
5. Select to start the test cycle. The test results will display at the
[Run]
conclusion of the test cycle.
Note Select
[Stop]
before the test stops. Stopping the test may take a few minutes.
Front Panel Diagnostic Tests
Test
Check Inventory
Recalibrate Library
Test Lateral Motion
Test Magazine
Moves
, select to display additional administrative
[More]
.
or key to view available tests.
[-] [+]
to abort a test. The current test cycle completes
Physically scans the entire library to determine
which slots and drives contain tapes and reads all
bar code labels.
Performs the power-up self-tests. Each test runs one
time per test loop. This test recalibrates the
mechanics and clears hard errors, but not the hard
error log.
Moves the transport assembly to a random slot. No
tape is required.
Moves a tape from a random slot to an empty,
random slot, and then returns it to the original
location.
Description
Chapter 4
Table 28