Lldp Notification Remote-Change Enable; Lldp Timer Notification-Interval - HP 6125G Command Reference Manual

Use undo lldp management-address-tlv to disable management address advertising in LLDPDUs.
By default, the management address is advertised through LLDPDUs. The management address is the
main IP address of the lowest-ID VLAN carried on the port. If none of the carried VLANs is assigned an
IP address, no management address will be advertised.
An LLDPDU carries only one management address TLV. If you set the management address repeatedly,
the latest one takes effect.
If you run the lldp management-address-tlv command without specifying the ip-address argument, the
advertised management address is the main IP address of the lowest-ID VLAN carried on the interface.
If none of the carried VLANs is assigned an IP address, no management address will be advertised.
Examples
# Set the management address to 192.6.0.1 for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp management-address-tlv 192.6.0.1

lldp notification remote-change enable

Syntax
lldp notification remote-change enable
undo lldp notification remote-change enable
View
Layer 2 Ethernet interface view
Default level
2: System level
Parameters
None
Description
Use lldp notification remote-change enable to enable LLDP trapping for a port.
Use undo lldp notification remote-change enable to disable LLDP trapping.
By default, LLDP trapping is disabled on ports.
Examples
# Enable LLDP trapping for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp notification remote-change enable

lldp timer notification-interval

Syntax
lldp timer notification-interval interval
undo lldp timer notification-interval
221