HP 6125G Command Reference Manual page 220

<Sysname> display lldp status
Global status of LLDP: Enable
The current number of LLDP neighbors: 0
The current number of CDP neighbors: 0
LLDP neighbor information last changed time: 0 days,0 hours,0 minutes,0 seconds
Transmit interval
Hold multiplier
Reinit delay
Transmit delay
Trap interval
Fast start times
Port 1 [GigabitEthernet1/0/1]:
Port status of LLDP
Admin status
Trap flag
Polling interval
Number of neighbors
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown TLV : 0
Table 50 Command output
Field
Global status of LLDP
LLDP neighbor information last
changed time
Transmit interval
Hold multiplier
Reinit delay
Transmit delay
Trap interval
Fast start times
Port 1
Port status of LLDP
Admin status
Trap Flag
Polling interval
: 30s
: 4
: 2s
: 2s
: 5s
: 3
: Enable
: Tx_Rx
: No
: 0s
: 0
: 0
: 0
: 23
Description
Indicates whether or not LLDP is globally enabled.
Time when the neighbor information was last updated.
LLDPDU transmit interval.
TTL multiplier.
LLDP re-initialization delay.
LLDPDU transmit delay.
Trap transmit interval.
Number of the LLDPDUs sent each time fast LLDPDU transmission is
triggered.
LLDP status of port 1.
Indicates whether or not LLDP is enabled on the port.
LLDP mode of the port:
•
TxRx—The port sends and receives LLDPDUs.
•
Rx_Only—The port only receives LLDPDUs.
•
Tx_Only—The port only sends LLDPDUs.
•
Disable—The port does not send or receive LLDPDUs.
Indicates whether or not trapping is enabled.
LLDP polling interval, which is 0 when LLDP polling is disabled.
212