Loopback-Detection Interval-Time; Loopback-Detection Per-Vlan Enable - HP 6125G Command Reference Manual

Examples
# Enable loopback detection on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] loopback-detection enable
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] loopback-detection enable

loopback-detection interval-time

Syntax
loopback-detection interval-time time
undo loopback-detection interval-time
View
System view
Default level
2: System level
Parameters
time: Sets the loopback detection interval, ranging from 5 to 300 seconds.
Description
Use loopback-detection interval-time to set the loopback detection interval.
Use undo loopback-detection interval-time to restore the default loopback detection interval.
The default loopback detection interval is 30 seconds.
Related commands: display loopback-detection.
Examples
# Set the loopback detection interval to 10 seconds.
<Sysname> system-view
[Sysname] loopback-detection interval-time 10

loopback-detection per-vlan enable

Syntax
loopback-detection per-vlan enable
undo loopback-detection per-vlan enable
View
Ethernet interface view
Default level
2: System level
Parameters
None
26