Stp Pathcost-Standard; Stp Point-To-Point - HP 6125G Command Reference Manual

<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp no-agreement-check

stp pathcost-standard

Syntax
stp pathcost-standard { dot1d-1998 | dot1t | legacy }
undo stp pathcost-standard
View
System view
Default level
2: System level
Parameters
dot1d-1998: Configures the device to calculate the default path cost for ports based on IEEE
802.1d- 1 998.
dot1t: Configures the device to calculate the default path cost for ports based on IEEE 802.1t.
legacy: Configures the device to calculate the default path cost for ports based on a private standard.
Description
Use stp pathcost-standard to specify a standard for the device to use when calculating the default path
costs for ports.
Use undo stp pathcost-standard to restore the default.
By default, the switch calculates the default path cost for ports based on a private standard.
If you change the standard that the device uses in calculating the default path costs, you restore the path
costs to the default.
Related commands: stp cost and display stp.
Examples
# Configure the device to calculate the default path cost for ports based on IEEE 802.1d- 1 998.
<Sysname> system-view
[Sysname] stp pathcost-standard dot1d-1998

stp point-to-point

Syntax
stp point-to-point { auto | force-false | force-true }
undo stp point-to-point
View
Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
115