Lldp Management-Address-Tlv; Lldp Notification Remote-Change Enable - HP 830 Command Reference Manual

[Sysname-Ten-GigabitEthernet1/0/1] lldp management-address-format string

lldp management-address-tlv

Use lldp management-address-tlv to enable management address advertising and set the management
address.
Use undo lldp management-address-tlv to disable management address advertising in LLDP frames.
Syntax
lldp management-address-tlv [ ip-address ]
undo lldp management-address-tlv
Default
The management address is advertised through LLDP frames. For a Layer 2 Ethernet port, the
management address is the main IP address of the lowest-ID VLAN carried on the port. If none of the
carried VLANs is assigned an IP address, no management address will be advertised.
Views
Layer 2 Ethernet interface view, port group view
Default command level
2: System level
Parameters
ip-address: Specifies a management address to be advertised in LLDP frames.
Usage guidelines
An LLDP frame carries only one management address TLV. If you set the management address repeatedly,
the latest one takes effect.
In Layer 2 Ethernet interface view, if you run the lldp management-address-tlv command without
specifying the ip-address argument, the advertised management address is the main IP address of the
lowest-ID VLAN carried on the interface. If none of the carried VLANs is assigned an IP address, no
management address will be advertised.
Examples
# Set the management address to 192.6.0.1 for Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] lldp management-address-tlv 192.6.0.1

lldp notification remote-change enable

Use lldp notification remote-change enable to enable LLDP trapping for a port or all ports in a port
group.
Use undo lldp notification remote-change enable to disable LLDP trapping.
Syntax
lldp notification remote-change enable
undo lldp notification remote-change enable
121