HP 6125G Command Reference Manual page 50

Field
Line protocol current state
Description
The Maximum Transmit Unit
Internet protocol processing
Physical is loopback
Last clearing of counters
Last 300 seconds input: 0 bytes/sec, 0
bits/sec, 0 packets/sec
Last 300 seconds output: 0 bytes/sec, 0
bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
The brief information of interface(s) under
route mode
Link: ADM - administratively down; Stby -
standby
Description
State of the data link layer protocol: up (spoofing). Spoofing refers
to the spoofing attribute of the interface. When the network layer
protocol state of the interface is displayed as up, the
corresponding link may not exist, or the corresponding link is
non-permanent and established on demand.
Description string of the interface.
Maximum transmission unit (MTU) of the interface.
State (enabled or disabled) of the network layer protocol
(displayed as Internet Address is X.X.X.X/XX Primary).
The physical type of the interface is loopback.
Time when statistics on the logical interface were last cleared by
using the reset counters interface command.
If the statistics of the interface have never been cleared by using
the reset counters interface command since device startup, this
field displays Never.
Average input rate during the last 300 seconds (displayed when
the interface supports traffic accounting), where the following
conditions apply:
•
packets/sec indicates the average number of packets received
per second.
•
bytes/sec indicates the average number of bytes received per
second.
•
bits/sec indicates the average number of bits received per
second.
Average output rate over the last 300 seconds (displayed when
the interface supports traffic accounting), where the following
conditions apply:
•
packets/sec indicates the average number of packets sent per
second.
•
bytes/sec indicates the average number of bytes sent per
second.
•
bits/sec indicates the average number of bits sent per second.
Total number and size (in bytes) of input packets of the interface
and the number of dropped packets.
Total number and size (in bytes) of output packets of the interface
and the number of dropped packets.
Brief information about Layer 3 interfaces.
Link status:
•
ADM—The interface has been administratively shut down. To
recover its physical state, execute the undo shutdown
command.
•
Stby—The interface is operating as a backup interface.
42