Qinq Transparent-Vlan - HP 6125G Command Reference Manual

Description
Use qinq ethernet-type service-tag to configure the TPID value in SVLAN tags.
Use undo qinq ethernet-type service-tag to restore the TPID value in SVLAN tags to the default setting.
By default, the TPID value in SVLAN tags is 0x8100.
On a port with basic QinQ not enabled, the switch judges whether a frame is VLAN tagged based on
the SVLAN TPID value on the port.
Configured in Ethernet interface view, this command takes effect on the current port only. Configured in
Layer 2 aggregate interface view, this command takes effect on the Layer 2 aggregate interface and the
member ports in its aggregation group.
Examples
# Set the TPID value in the SVLAN tags to 0x9100 on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq ethernet-type service-tag 9100

qinq transparent-vlan

Syntax
qinq transparent-vlan vlan-list
undo qinq transparent-vlan { all | vlan-list }
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
vlan-list: Specifies a list of existing VLANs in the format of vlan-list = { vlan-id1 [ to vlan-id2 ] }&<1- 1 0>,
where vlan-id1 and vlan-id2 represent the VLAN IDs and each range from 1 to 4094, vlan-id2 cannot be
smaller than vlan-id1, and &<1- 1 0> indicates that you can specify up to 10 vlan-id1 [ to vlan-id2 ]
parameters.
all: Indicates all VLANs.
Description
Use qinq transparent-vlan to configure VLAN transparent transmission on one or multiple ports, so the
port or ports can transparently transmit frames from the specified VLANs.
Use undo qinq transparent-vlan to remove the configuration.
By default, VLAN transparent transmission is not configured on ports.
Configured in Layer 2 Ethernet interface view, the command takes effect on the interface only.
Configured in Layer 2 aggregate interface view, the command takes effect on the Layer 2 aggregate
interface and all the member ports in the aggregation group.
Examples
# Enable basic QinQ on GigabitEthernet 1/0/1, and configure GigabitEthernet 1/0/1 to transparently
transmit frames from VLAN 2, VLAN 3, and VLAN 50 through VLAN 100.
197