Stp Transmit-Limit - HP 6125G Command Reference Manual

After the network topology is stabilized, each non-root-bridge device forwards configuration BPDUs to
the surrounding devices at the interval of hello time to check whether any link is faulty. If a device does
not receive a BPDU from the upstream device within nine times the hello time, it will assume that the
upstream device has failed and start a new spanning tree calculation process.
In a stable network, this kind of spanning tree calculation may occur because the upstream device is busy.
You can avoid such unwanted spanning tree calculations by lengthening the timeout time (by setting the
timeout factor to 4 or more), saving the network resources. HP recommends you to set the timeout factor
to 5, 6, or 7 for a stable network.
Related commands: stp timer hello.
Examples
# Set the timeout factor of the device to 7.
<Sysname> system-view
[Sysname] stp timer-factor 7

stp transmit-limit

Syntax
stp transmit-limit limit
undo stp transmit-limit
View
Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
limit: Sets the maximum number of BPDUs the ports can send within each hello time, in the range of 1 to
255.
Description
Use stp transmit-limit to set the maximum number of BPDUs that the ports can send within each hello
time.
Use undo stp transmit-limit to restore the default.
By default, the maximum transmission rate of all ports is 10. Each port can send up to 10 BPDUs within
each hello time.
Configured in Ethernet interface view, the setting takes effect only on the interface.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate interface.
Configured on a member port in an aggregation group, the setting takes effect only after the port leaves
the aggregation group.
A larger maximum transmission rate value requires more system resources. An appropriate maximum
transmission rate setting can prevent spanning tree protocols from using excessive bandwidth resources
during network topology changes. HP recommends that you use the default value.
Examples
# Set the maximum transmission rate of port GigabitEthernet 1/0/1 to 5.
<Sysname> system-view
126