Lldp Admin-Status; Lldp Check-Change-Interval - HP 6125G Command Reference Manual

Field
LLDP-MED extend TLV

lldp admin-status

Syntax
lldp admin-status { disable | rx | tx | txrx }
undo lldp admin-status
View
Layer 2 Ethernet interface view
Default level
2: System level
Parameters
disable: Specifies the Disable mode. A port in this mode does not send or receive LLDPDUs.
rx: Specifies the Rx mode. A port in this mode only receives LLDPDUs.
tx: Specifies the Tx mode. A port in this mode only sends LLDPDUs.
txrx: Specifies the TxRx mode. A port in this mode sends and receives LLDPDUs.
Description
Use lldp admin-status to specify the LLDP operating mode for a port.
Use undo lldp admin-status to restore the default LLDP operating mode.
By default, the LLDP operating mode is TxRx.
Examples
# Configure the LLDP operating mode as Rx for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp admin-status rx

lldp check-change-interval

Syntax
lldp check-change-interval interval
undo lldp check-change-interval
Description
LLDP-MED TLVs:
•
Capabilities TLV
•
Network Policy TLV
•
Extended Power-via-MDI TLV
•
Location Identification TLV
•
Inventory TLV, including hardware revision TLV, firmware revision TLV,
software revision TLV, serial number TLV, manufacturer name TLV,
model name TLV, and asset id TLV
215