<Sysname> system-view
[Sysname] undo link-aggregation load-sharing mode local-first
link-aggregation mode
Syntax
link-aggregation mode dynamic
undo link-aggregation mode
View
Layer 2 aggregate interface view
Default level
2: System level
Parameters
None
Description
Use the link-aggregation mode dynamic command to configure an aggregation group to operate in
dynamic aggregation mode.
Use undo link-aggregation mode to restore the default setting.
By default, an aggregation group operates in static aggregation mode.
To change the aggregation mode of an aggregation group that contains member ports, remove all the
member ports from the aggregation group first.
Examples
# Configure the aggregation group corresponding to Bridge-Aggregation 1 to operate in dynamic
aggregation mode.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic
link-aggregation port-priority
Syntax
link-aggregation port-priority port-priority
undo link-aggregation port-priority
View
Ethernet interface view
Default level
2: System level
Parameters
port-priority: Specifies a port aggregation priority, in the range of 0 to 65535. The smaller the value, the
higher the port aggregation priority.
79