HP 6125G Command Reference Manual page 76

|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display link-aggregation load-sharing mode to display global or group-specific link-aggregation
load sharing criteria.
To display the global link-aggregation load sharing criteria, run the command without the interface
keyword.
To display all the group-specific load sharing criteria, run the command with the interface keyword, but
do not specify a particular interface.
To display the load sharing criterion or criteria of a particular aggregation group, perform the command
with the aggregate interface specified.
The bridge-aggregation keyword becomes available only after you create Layer 2 aggregate interfaces
on the device.
Examples
# Display the global link-aggregation load sharing criteria.
<Sysname>display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
Layer 2 traffic: packet type-based sharing
Layer 3 traffic: destination-ip address,
# Display the default link-aggregation load sharing criteria of the aggregation group corresponding to
Layer 2 aggregate interface Bridge-Aggregation 10.
<Sysname>display link-aggregation load-sharing mode interface Bridge-Aggregation 10
Bridge-Aggregation1 Load-Sharing Mode:
Layer 2 traffic: packet type-based sharing
Layer 3 traffic: destination-ip address,
Table 17 Command output
Field
Link-Aggregation Load-Sharing
Mode
Bridge-Aggregation10
Load-Sharing Mode
Layer 3 traffic: destination-ip
address, source-ip address
Layer 2 traffic: packet type-based
sharing
source-ip address
source-ip address
Description
Global link-aggregation load sharing criteria.
Link-aggregation load sharing criteria of the aggregation group
corresponding to the aggregate interface Bridge-Aggregation 10.
Default link-aggregation load sharing criteria for Layer 3 traffic. In this
sample output, the criteria are the source and destination IP addresses of
packets.
Default link-aggregation load sharing criterion for Layer 2 traffic. In this
sample output, the criterion is the packet type.
68