Appletalk Menu - Lexmark MS312 User Manual

Understanding the printer menus
Use
Protocol
Standard
Fastbytes
Honor Init
On
Off
Parallel Mode 2
On
Off
Mac Binary PS
On
Off
Auto
ENA Address
yyy.yyy.yyy.yyy
ENA Netmask
yyy.yyy.yyy.yyy
ENA Gateway
yyy.yyy.yyy.yyy

AppleTalk menu

To access the menu, navigate to either of the following:
• Network/Ports > Standard Network > Standard Network Setup > AppleTalk
•
Network/Ports > Network [x] > Network [x] Setup > AppleTalk
Use
Activate
Yes
No
To
Specify the parallel port protocol.
Notes:
•
Fastbytes is the factory default setting. It provides compatibility with most
existing parallel ports and is the recommended setting.
• Standard tries to resolve parallel port communication problems.
Determine if the printer honors printer hardware initialization requests from the
computer.
Notes:
•
Off is the factory default setting.
•
The computer requests initialization by activating the Init signal from the
parallel port. Many personal computers activate the Init signal each time the
computer is turned on.
Determine if the parallel port data is sampled on the leading or trailing edge of a
strobe.
Note: On is the factory default setting.
Set the printer to process Macintosh binary PostScript print jobs.
Notes:
•
Auto is the factory default setting.
• Off filters print jobs using the standard protocol.
•
On processes raw binary PostScript print jobs.
Set the network address information for an external print server.
Note: This menu item is available only if the printer is attached to an external print
server through the USB port.
Set the netmask information for an external print server.
Note: This menu item is available only if the printer is attached to an external print
server through the USB port.
Set the gateway information for an external print server.
Note: This menu item is available only if the printer is attached to an external print
server through the USB port.
To
Enable or disable AppleTalk support.
Note: No is the factory default setting.
98