Configure The Media Sizes - Oce ColorWave 650 User Manual

Configure the media sizes

Introduction
You must indicate in the Océ Express WebTools the following settings.
•
The core size of the media rolls
•
The media sizes
How to define the core size of the media
Attention:
Access the Océ Express WebTools. This setting is editable for the Key operator and the
Power user.
Navigate to 'Configuration' - 'Printer setup'.
1.
Click 'Edit' in the 'Media' bar or click the value of the 'Two-inch core used' setting if
2.
you also use 2 inch cores.
The standard roll core size for the Océ ColorWave 650 is 3 inch. If 'Two-inch core used'
is enabled, the printer will ask the used core size when loading a media roll.
Click 'Ok' to confirm your entries or 'Cancel' to reject your entries.
3.
How to define the media sizes
Attention:
Access the Océ Express WebTools. This setting is editable for the System Administrator
and the Power user.
Navigate to the 'Support' - 'Media' tab.
1.
Click on the value of the 'Supported media sizes' setting. A new window opens.
2.
Select a media series from the drop-down list. For each of the standard media series
3.
('ANSI small', 'DIN', 'ANSI mixed' or 'DIN Carto') a set of media sizes is enabled.
You can enable or disable media sizes to tune the system to your environment. The media
4.
series will then automatically change into a 'Custom' media series.
Click 'Ok' to confirm your entries or 'Cancel' to reject your entries.
5.
Chapter 7 - Manage media on the Océ ColorWave 650 printing system
Configure the media sizes
299