Calibrate The Océ Colorwave 650 Printer - Oce ColorWave 650 User Manual

Calibrate the Océ ColorWave 650 printer
Calibrate the Océ ColorWave 650 printer
When to do
Note:
Only roll position 1 can be used for calibrations.
Note:
Use only Océ 'Media' for reliable calibrations.
Note:
The printer will do the calibration automatically. You do not need to keep this printed
calibration chart.
Evaluate the Customer Analysis Tool print. If the print shows any output quality problems,
you can use this calibration wizard to check if the Océ ColorWave 650 works properly.
The calibration will take a several minutes. The printed output is delivered at the rear
side of the printer and lead through the slot below the 'Top back cover'.
Attention:
In case a copy delivery tray is installed, remove the copy delivery tray from the engine
and remove the copy delivery tray data-cable from the controller before you start the
calibration.
Attention:
In case a folder is installed, make sure that the folder is switched ON and lift the bridge
before you start the calibration.
402 Chapter 8 - Print quality and Print productivity