4
How to solve the problem
Check if the system compensates for the nozzle dropout during the next swath.
1.
If the system does not compensate for the nozzle dropout, you must print the Customer
2.
Analysis Tool.
Check the coloured bars of the test print.
3.
Note:
Either check the test print on the second half of the print or reprint the Customer Anal-
ysis Tool and check the second print. When the coloured bars are OK, the system functions
correctly. However, it is always advised to switch to a higher print mode.
Select a higher print mode, even when you use the 'Océ Print Assistant'.
4.
Try to print on another media.
5.
If the coloured bars of the Customer Analysis Tool demo print still show lines, contact
6.
the Océ Helpdesk.
Thin horizontal, coloured or white lines across your print
Yellow
Chapter 8 - Print quality and Print productivity
401