Cover Or Drawer Opened - Oce ColorWave 650 User Manual

Cover or drawer opened

Introduction
The media drawers and certain covers must only be opened if you are asked to do so in
a wizard on the printer user panel.
Attention:
When you open one of the indicated covers or drawers while you are not in a wizard, the
system produces a warning signal. The red LED on the printer user panel illuminates.
Attention:
When you open one of these covers or drawers during printing, the printer stops and the
printer user panel shows one of the warnings that are listed in the table below. When you
closed the indicated cover or drawer, the print is cut and the print job is sent to printer
again.
#
Displayed warning Position of the component
'Media drawer' [2, 3, 4]
4
3
2
Note:
Normally you open a media drawer to
load or replace a media roll or in case of a
media jam.
Chapter 5 - Use the printing system
Cover or drawer opened
201