Set The 'Océ Finishing Assistant - Oce ColorWave 650 User Manual

Set the 'Océ Finishing Assistant'
Set the 'Océ Finishing Assistant'
Introduction
This setting is only available when the 'Configuration' - 'Printer setup' - 'Finishing' -
'Finisher configuration type' setting is set to 'Integrated Es-te folder'.
The 'Océ Finishing Assistant' can automatically detect the legend (if present) of a drawing
and rotate and align the drawing so the legend will be on the cover page of the fold
package. If no legend can be detected the print is delivered unfolded.
When enabled, the 'Océ Finishing Assistant' overrules the default rotation and alignment
settings for folded output.
Before you begin
This setting is editable for the Key operator or Power user.
How to set the 'Océ Finishing Assistant'
Click 'Preferences' - 'Print job defaults' - 'Layout'.
1.
Click 'Edit' in the 'Layout' bar or click the value of the 'Océ Finishing Assistant' setting.
2.
Select 'Enabled' if the printer must automatically detect the legend of your drawings and
3.
fold the drawings correctly.
Click 'Ok' to confirm your entries or 'Cancel' to reject your entries.
4.
166 Chapter 4 - Configure the printing system