Lower Connector; Removing The Feeder Control Board Cover Plate - Tektronix 1235N - Phaser Color Laser Printer Service Manual

Lower connector

Warning Switch off the power and disconnect the power cord.
1. Remove the printer from the optional paper feeder.
2.
Remove the paper tray 2 from the feeder.
3.
Separate feeder 2 from feeder 3
4. Remove the four screws securing the feeder control board cover plate.
Remove the plate.

Removing the feeder control board cover plate

5.
Disconnect harness MAIN2 from the feeder control board.
6. Set the feeder so that the front extends over the edge of the work surface
by 6 in. (152mm).
7. Remove the two screws securing the lower connector to the bottom of
the feeder.
Service Guide 181