Paper size sensing board
Warning
Switch off the power and disconnect the power cord.
1.
Remove the printer from the optional paper feeder.
Note
If removing the size sensing board from feeder 3, remove feeder 2
from feeder 3.
2.
Remove the paper tray from the feeder.
3.
Remove the four screws securing the feeder control board cover plate.
Remove the plate.
4.
Disconnect flat harness PSZ from the feeder control board.
5.
Remove the paper size actuator as detailed in the topic "Paper size
sensing actuator" on page 179.
6.
Remove the screw securing the paper size sensing board to the feeder
frame. Remove the board.
Removing the paper size sensing board
Reverse these steps to install the paper size sensing board.
180
Phaser 1235 Network Color Printer