Multi-sheet bypass feeder entrance sensor actuator
Warning
Switch off the power and disconnect the power cord.
1.
Remove the multi-sheet bypass feeder as described in the topic on
page 127.
2.
Remove the printer unit chassis as described in the topic on page 97.
3.
Remove the Tray 1 entrance sensor actuator as detailed in the topic on
page 130.
4.
Remove the entrance sensor board as shown on page 113.
5.
From the bottom, squeeze the two locking tabs securing the multi-sheet
bypass feeder entrance sensor actuator.
6.
Remove the actuator from the top.
Removing the multi-sheet bypass feeder entrance sensor actuator
Reverse these steps to install the multi-sheet bypass feeder entrance sensor
actuator. Ensure that the spring arm is in the notch in the frame.
Service Guide
129