Table of Contents
Advertisement
Main cooling fan
Warning
Switch off the power and disconnect the power cord.
1.
Open the top cover. Remove the drum/toner cartridge basket. Cover
the basket in a lightproof black bag and store in a safe place.
2.
Open the front cover.
3.
Remove the left-side cover as detailed in the topic "Left-side cover" on
page 88. Also remove the left-side shield plate.
4.
Remove the rear shield plate; it is secured by four screws.
5.
Remove the left shield plate; it is secured by ten screws.
6.
Remove the rear cover as described in "Rear cover" on page 90.
7.
Disconnect the main cooling fan's wiring harness from the low voltage
power supply board.
8.
Slide the main cooling fan out of the printer frame.
Removing the main cooling fan
Reverse these steps to install the main cooling fan.
Service Guide
99
Advertisement
Table of Contents
Troubleshooting
