Stack Full Sensor; Removing The Led Assembly Power Connector - Tektronix 1235N - Phaser Color Laser Printer Service Manual

Stack full sensor

Warning Switch off the power and disconnect the power cord.
1. Remove the top cover.
2.
Disconnect the four LED assembly power harnesses from the bottom of
the toner sensor board.

Removing the LED Assembly power connector

3.
Close the top cover inner unit.
4. Remove the four screws securing the metal shield over the toner
cartridge sensor board.
5. Remove the three screws securing the toner sensor board.
6.
Rotate the board up to expose the component side of the board.
7.
Disconnect the STUCK connector from the toner sensor board.
8. Free the disconnected cable from all cable retainers.
9.
Release the four locking tabs securing the stack full sensor.
Service Guide 149