Table of Contents
Advertisement
Tray 1 no-paper/low-paper sensors
Warning
Switch off the power and disconnect the power cord.
1.
Remove the electrical chassis as detailed in "Electrical chassis (card
cage)" on page 94.
2.
Remove the printer chassis as described in the topic "Printer unit
chassis (and low-voltage power supply fan)" on page 97.
3.
Remove the main feeder assembly as described in the previous
procedure "Main feeder assembly" on page 123.
4.
The no-paper and low-paper sensors are not spared separately. If either
sensor is defective, replace the main feeder assembly.
Removing the lower plate assembly
Reverse these steps to install the main feeder assembly.
Service Guide
125
Advertisement
Table of Contents
Troubleshooting
