LED assembly
Warning
Switch off the power and disconnect the power cord.
1.
Open the top cover. Remove the drum/toner cartridge basket. Cover
the basket in a lightproof black bag and store in a safe place.
2.
Carefully disconnect the flat harness connector from the LED assembly
by inserting a small, flat-blade screwdriver through the hole in the end
of the LED assembly and lifting up on the connector. Free the harness
from the LED assembly.
3.
Disconnect the power harness from the toner sensor board.
4.
Note the two springs on the back of the LED assembly. Ensure they
remain with the top cover inner frame.
5.
Rotate the LED assembly down until the locking tabs align with the
slots in the frame.
6.
Carefully spread the mounting frame out to free the LED assembly.
7.
Remove the LED assembly.
Removing an LED assembly
Reverse these steps to install the LED assembly.
Service Guide
159