Low Voltage Power Supply; Removing The Low Voltage Power Supply - Tektronix 1235N - Phaser Color Laser Printer Service Manual

Low voltage power supply

Warning
Switch off the power and disconnect the power cord.
1.
Remove the printer unit chassis as shown on page 97.
2. Disconnect CN3, CN1, & CN2 from the low voltage power supply.
3.
Remove the six screws securing the low voltage power supply to the
printer. Disconnect the AC ground wire from the printer frame.
4.
Lift the power switch (SW1) and the low voltage power supply to
remove.

Removing the low voltage power supply

Reverse these steps to install the low voltage power supply.
116 Phaser 1235 Network Color Printer