Rear Cover; Removing The Rear Cover - Tektronix 1235N - Phaser Color Laser Printer Service Manual

Rear cover

Warning
Switch off the power and disconnect the power cord.
1.
Open the top cover. Remove the drum/toner cartridge basket. Cover
the basket in a lightproof black bag to protect the drum units from light
and store in a safe place.
2.
Open the front cover.
3.
Remove the left side cover as detailed in the topic "Left-side cover" on
page 88.
4.
Remove the right side cover as detailed in the topic "Right-side cover"
on page 89.
5.
Close the top cover.
6. Remove the four screws securing the rear cover to the printer.
7.
Remove the rear cover.

Removing the rear cover

To install the rear cover, open the face up tray.
Note
Ensure that the face up tray gate spring extends out the face up
tray opening.
Reverse the removal steps to install the rear cover. Install the rear cover with the
face-up tray in the open position to ensure the gate spring is properly located.
The end of the spring should protrude out when the tray is opened, allowing the
gate to open (which deflects the print into the face-up tray).
90 Phaser 1235 Network Color Printer
Note spring for
reassembly