Cap/Wipe/Purge Assembly (Phaser 850 Printer); Removing The Lower Cap/Wipe/Purge Retainer Clip - Tektronix PHASER 840 Service Manual

Cap/wipe/purge assembly (Phaser 850 printer)

Warning
Even when the printer is turned off, AC line voltages may be
present at the printer heaters while the printer is plugged into AC
power.
1. Remove the right cover. Remove the left cover.
2.
Disconnect the head-tilt spring.
3. Remove the top cover.
4.
Remove the ink loader.
5. Remove the metal heat duct over the printhead.
6.
Tilt back the printhead and center it.
7. Remove the maintenance drawer.
8.
Remove the right maintenance drawer guide.
Right
maintenance
drawer guide

Removing the lower cap/wipe/purge retainer clip

9.
Disconnect the wiring harness leading from the cap/wipe/purge
assembly to the power supply wiring harness. Clip the tie wraps
securing the cap/wipe/purge wiring harness. Disconnect the green
ground wire from the printer frame.
150
Phaser 840 and 850 Color Printers
840-4-80