Feeder clutch
Warning
Switch off the power and disconnect the power cord.
1.
Remove the printer from the optional paper feeder.
2.
Remove the paper tray from the feeder.
3.
Remove the four screws securing the feeder control board cover plate.
Remove the plate.
Removing the feeder control board cover
4.
Remove the idler roller assembly as explained on page 164.
5.
Remove the inner frame as detailed on page 166
6.
Disconnect the CL1 harness from the feeder control board.
7.
Remove the E-ring securing the feeder clutch to the shaft.
Service Guide
169