Example: Adding A System Board; Figure - Fujitsu Siemens Computers SPARC Enterprise M5000 User Manual

4.2

Example: Adding a System Board

This section provides an example of the DR operation to add a system board to a
domain. In the example, a procedure conforming to section
Adding a System
added by using the XSCF shell.

FIGURE 4-5

Domain#0
1. Login to XSCF.
2. Check the status of the domain.
Execute the showdcl(8) command to display domain information, and then
check the operation status of the domain. Based on the operation status of the
domain, determine whether to perform the DR operation or change the domain
configuration.
XSCF> showdcl -d 0
DID
00
3. Check the status of the system board to be added.
Execute the showboards(8) command to display system board information, and
then check the status of the system board to be added and confirm its registration
in the DCL.
4-6 SPARC Enterprise Mx000 Servers Dynamic Reconfiguration User's Guide • September 2007
Board.", is used, and the system board shown in the figure is

Example: Adding a System Board

XSB#00-0
XSB#01-0
LSB XSB Status
Running
00 00-0
01 01-0
<LinkColor>4.1.1, "Flow:
Domain#0
XSB#00-0
Add
XSB#01-0