Fujitsu Siemens Computers SPARC Enterprise M5000 User Manual page 114

3. Check the status of the move-destination domain.
Execute the showdcl(8) command to display domain information, and then
check the operation status of the move-destination domain. Based on the
operation status of the move-source and move-destination domains, determine
whether to perform the DR operation or change the domain configuration.
XSCF> showdcl -d 0
DID
00
4. Check the status of the system board to be moved.
Execute the showboards(8) command to display system board information, and
then check the status of the system board to be moved.
XSCF> showboards 01-0
XSB
------------------------------------------------------------------
01-0
5. Reserve the move of the system board.
Execute the moveboard(8) command to reserve deletion of the system board
from the move-source domain and addition of the system board to the move-
destination domain.
XSCF> moveboard -c reserve -d 0 01-0
6. Check the reserved status of the system board.
Execute the showboards(8) command with the -v option specified to display
system board information, and confirm that moving the system board to the
move-destination domain has been reserved.
XSCF> showboards -v 01-0
XSB
--------------------------------------------------------------------------
01-0
7. Stop the move-source domain.
Stop the move-source domain. This operation executes the reserved deletion of
the system board from the move-source domain as a change in domain
configuration, and the reservation of the addition of the system board to the
move-destination domain.
4-24 SPARC Enterprise Mx000 Servers Dynamic Reconfiguration User's Guide • September 2007
LSB XSB Status
Running
00 00-0
01 00-1
02 01-0
DID(LSB) Assignment
01(00) Assigned
R DID(LSB) Assignment
* 01(00) Assigned
Pwr Conn Conf
y y y
Pwr Conn Conf
y y y
Test Fault
Passed Normal
Test Fault
Passed Normal
COD
n