Fujitsu Siemens Computers SPARC Enterprise M5000 User Manual page 104

4. Delete the system board.
Execute the deleteboard(8) command to delete the system board.
XSCF> deleteboard -c disconnect 01-0
5. Check the status of the system board.
Execute the showboards(8) command to display system board information, and
then check the status of the system board.
XSCF> showboards 01-0
XSB
-----------------------------------------------------------------
01-0
6. Physically replace the system board.
Execute the replacefru(8) command, then follow the displayed instructions to
replace the system board per the Hot Replacement procedure. For information
about Hot Replacement, see the SPARC Enterprise M8000/M9000 Servers Service
Manual.
XSCF> replacefru
7. Check the status of the replaced system board.
Execute the showboards(8) command to display system board information, and
then check the status of all related system boards and confirm their registration
in the DCL.
If necessary to change the system board configuration (e.g., number of divisions),
do so by using the setupfru(8) command. If the system board is not registered
in the DCL, register it in the DCL for the target domain by using the setdcl(8)
command.
XSCF> showboards 01-0
XSB
-----------------------------------------------------------------
01-0
4-14 SPARC Enterprise Mx000 Servers Dynamic Reconfiguration User's Guide • September 2007
DID(LSB) Assignment
00(01) Assigned
DID(LSB) Assignment
00(01) Assigned
Pwr Conn Conf
y n n
Pwr Conn Conf
y n n
Test Fault
Passed Normal
Test Fault
Passed Normal