Fujitsu Siemens Computers SPARC Enterprise M5000 User Manual page 97

If you need to change the PSB configuration, use the setupfru(8) command. If
the system board to be added is not registered in the DCL, register the system
board in the DCL of the target domain by using the setdcl(8) command.
XSCF> showboards -a
XSB DID(LSB) Assignment
----------------------------------------------------------------
00-0 00(00) Assigned
01-0 SP Available
4. Add the new system board.
Execute the addboard(8) command to add the system board to the move-
destination domain.
XSCF> addboard -c configure -d 0 01-0
5. Check the status of the domain and added system board.
When the addboard(8) command ends normally, execute the showdcl(8)
command to check the operation status of the domain, and then execute the
showboards(8) command to check the status of the added system board.
If the addboard(8) command completes abnormally or leaves the board in an
unwanted status, refer output messages to identify the problem, then correct it.
XSCF> showdcl -d 0
DID LSB XSB
00
00 00-0
01 01-0
XSCF> showboards -d 0
XSB DID(LSB) Assignment
------------------------------------------------------------------
00-0 00(00) Assigned
01-0 00(01) Assigned
Pwr Conn
y y
y n
Status
Running
Pwr Conn
y y
y y
Conf Test Fault
y Passed Normal
n Passed Normal
Conf Test Fault
y Passed Normal
y Passed Normal
Chapter 4 Practical Examples of DR 4-7