Fujitsu Siemens Computers SPARC Enterprise M5000 User Manual page 101

3. Check the status of the move-destination domain.
Execute the showdcl(8) command to display domain information, and then
check the operation status of the move-destination domain. Based on the
operation status of the move-source and move-destination domains, determine
whether to perform the DR operation or change the domain configuration.
XSCF> showdcl -d 1
DID LSB XSB
01
00 01-0
01 00-1
4. Check the status of the system board to be moved.
Execute the showboards(8) command to display system board information, and
then check the status of the system board to be moved.
XSCF> showboards 00-1
XSB DID(LSB) Assignment
---- -------- ----------- ---- ---- ---- ------- ---------------
00-1 00(01) Assigned
5. Move the system board.
Execute the moveboard(8) command to delete the system board from the move-
source domain and add it to the move-destination domain.
XSCF> moveboard -c configure -d 1 00-1
6. Check the status of the move-source domain.
When the moveboard(8) command ends normally, execute the showdcl(8)
command to display and check the operation status of the move-source domain.
If the moveboard(8) command completes abnormally or leaves the board in an
unwanted status, refer output messages to identify the problem, then correct it.
XSCF> showdcl -d 0
DID LSB XSB
00
00 00-0
01 00-1
Status
Running
Pwr Conn
y y
Status
Running
Conf Test Fault
y Passed Normal
Chapter 4 Practical Examples of DR 4-11