Fujitsu Siemens Computers SPARC Enterprise M5000 User Manual page 111

2. Check the status of the system board to be added.
Execute the showboards(8) command to display system board information, and
then check the status of the system board to be added and confirm its registration
in the DCL.
If you need to change the PSB configuration, use the setupfru(8) command. If
the system board is not registered in the DCL, register the system board in the
DCL for the target domain by using the setdcl(8) command.
XSCF> showdcl -d 0
DID LSB XSB
00
00 00-0
01 01-0
XSCF> showboards 01-0
XSB DID(LSB) Assignment
------------------------------------------------------------------
01-0 SP Available
3. Reserve the addition of the system board.
Execute the addboard(8) command to reserve the addition of the system board.
XSCF> addboard -c reserve -d 0 01-0
4. Check the status of the system board.
When the addboard(8) command ends normally, execute the showboards(8)
command to display system board information, and then check the status of the
target system board and confirm that the addition of the target system board has
been reserved.
If the addboard(8) command ends abnormally, identify the cause of the
abnormality based on the messages output, and then take appropriate corrective
action.
XSCF> showboards -v 01-0
XSB R DID(LSB)
--------------------------------------------------------------------------
01-0 * SP
5. Stop or reboot the domain.
Stop or reboot the domain. This operation executes the reserved deletion of the
system board as a change in domain configuration.
Status
Running
Pwr Conn
y n
Assignment Pwr
Available y
Conf Test
n Passed
Conn Conf Test
n n Passed
Chapter 4 Practical Examples of DR
Fault
Normal
Fault COD
Normal n
4-21