Fujitsu Siemens Computers SPARC Enterprise M5000 User Manual page 99

3. Check the status of the system board to be deleted.
Execute the showboards(8) command to display system board information, and
then check the status of the system board to be deleted.
XSCF> showboards -a
XSB DID(LSB)
-------------------------------------------------------------------
00-0 00(00)
01-0 00(01)
4. Delete the system board.
Execute the deleteboard(8) command to delete the system board and pool it in
the system board pool.
XSCF> deleteboard -c unassign 01-0
5. Check the status of the domain and deleted system board.
When the deleteboard(8) command ends normally, execute the showdcl(8)
command to check the operation status of the domain, and then execute the
showboards(8) command to check the status of the deleted system board.
If the deleteboard(8) command completes abnormally or leaves the board in an
unwanted status, refer output messages to identify the problem, then correct it.
XSCF> showdcl -d 0
DID LSB XSB
00
00 00-0
01 01-0
XSCF> showboards -a
XSB DID(LSB) Assignment
----------------------------------------------------------------
00-0 00(00) Assigned
01-0 SP Available
Assignment Pwr
Assigned y
Assigned y
Status
Running
Pwr Conn
y y
y n
Conn Conf Test
y y Passed
y y Passed
Conf Test Fault
y Passed Normal
n Passed Normal
Chapter 4 Practical Examples of DR
Fault
Normal
Normal
4-9