Fujitsu Siemens Computers SPARC Enterprise M5000 User Manual page 108

6. Check the status of all related system boards.
Execute the showboards(8) command to display system board information, and
then check the status of all related system boards.
XSCF> showboards -a
XSB
------------------------------------------------------------------
00-0
01-0
01-1
01-2
01-3
7. Physically replace the system board.
Execute the replacefru(8) command, then follow the displayed instructions to
replace the system board per the Hot Replacement procedure. For information
about Hot Replacement, see the SPARC Enterprise M8000/M9000 Servers Service
Manual.
XSCF> replacefru
8. Check the status of the replaced system board.
Execute the showboards(8) command to display system board information, and
then check the status of the system board to be added and confirm its registration
in the DCL.
If you need to change the PSB configuration, use the setupfru(8) command. If
the system board is not registered in the DCL, register it in the DCL for the target
domain by using the setdcl(8) command.
XSCF> showboards -a
XSB
--------------------------------------------------------------------
00-0
01-0
01-1
01-2
01-3
4-18 SPARC Enterprise Mx000 Servers Dynamic Reconfiguration User's Guide • September 2007
DID(LSB) Assignment
00(00) Assigned
00(01) Assigned
00(02) Assigned
01(00) Assigned
01(01) Assigned
DID LSB) Assignment
00(00) Assigned
00(01) Assigned
00(02) Assigned
01(00) Assigned
01(01) Assigned
Pwr Conn Conf
y y y
y n n
y n n
y n n
y n n
Pwr Conn Conf
y y y
y n n
y n n
y n n
y n n
Test Fault
Passed Normal
Passed Normal
Passed Normal
Passed Normal
Passed Normal
Test Fault
Passed Normal
Passed Normal
Passed Normal
Passed Normal
Passed Normal