Fujitsu Siemens Computers SPARC Enterprise M5000 User Manual page 140

XSB#XX-X is currently unavailable for DR. Try again later.
[Explanation] The specified system board (XSB#XX-X) has already been executed
by another operation.
[Remedy] DR or power-off has been executing for another session. Try again after
waiting for a while, with the confirmation of the XSB status.
XSB#XX-X has not been registered in DCL.
[Explanation] System board (XSB#XX-X) is not registered to DCL.
[Remedy] Register DCL information by setdc(8).
Another DR operation is in progress. Try again later.
[Explanation] The specified system board (XSB#XX-X) has already been executed
by another session.
[Remedy] DR operation is in progress by another session. Try again after waiting
for a while, with the confirmation of the XSB status.
XSB#XX-X has been detected timeout by DR self test.
[Explanation] The timeout occurred during DR processing because the hardware
diagnosis did not complete. There is something wrong with the hardware.
[Remedy] Find out the cause of the DR failure referring monitoring message and
errorlog. Replace the failure component.
XSB#XX-X encountered a hardware error. See error log for
details.
[Explanation] An error occurred during hardware diagnosis. There is something
wrong with the hardware.
[Remedy] Find out the cause of the DR failure referring monitoring message and
errorlog. Replace the failure component.
IP address of DSCP path is not specified.
[Explanation] DR cannot communicate with the domain because the DSCP IP
Address is not set up or registered.
[Remedy] Register the DSCP IP Address.
An internal error has occurred. This may have been caused by a
DR library error.
[Explanation] The DR processing cannot be failed on the domain OS. The error
occurred at the DR library.
A-24 SPARC Enterprise Mx000 Servers Dynamic Reconfiguration User's Guide • September 2007