Asus DS300j G2 Series User Manual page 87

M ssh s
Aking ettings
To change SSH service settings:
1. Click the Administration tab.
2. Click the Services icon.
3. Click the SSH service and click the Settings button.
4. Make settings changes as required:
• Choose a startup type,
Automatic – (default) Starts and runs with the subsystem.
Manual – You start the service when you need it.
• Port number - Default is 22.
• Max Number of Concurrent Connections – Default is 4.
Maximum number is 4.
• Session Time Out - Default is 24 minutes.
5. Click the Save button.
6. Click the Confirm button.
SnmP S
ervIce
Simple Network Management Protocol (SNMP) service enables the SNMP browser to obtain information from
the RAID subsystem. The Trap Sink is where SNMP events are sent and can be viewed.
s snMP s
toPPing ervice
To stop the SNMP service:
1. Click the Administration tab.
2. Click the Services icon.
3. Click SNMP service and click the Stop button.
4. Click the Confirm button.
To start the SNMP service after stopping it:
1. Click the Administration tab.
2. Click the Services icon.
3. Click SNMP service and click the Start button.
r snMP s
estArting ervice
To restart the SNMP service:
81
1. Click the Administration tab.
2. Click the Services icon.
3. Click the SNMP service and click the Restart button.
M snMP s
Aking ettings
To change SNMP service settings:
1. Click the Administration tab.
2. Click the Services icon.
3. Click the SNMP service and click the Settings button.
4. Make settings changes as required:
• Choose a startup type,
Automatic – (default) Starts and runs with the subsystem.
Manual – You start the service when you need it.
• Port Number – Default is 161.
• System Name – No default.
• System Location – Default is USA.
• System Contact – Default is admin@yourcompany.com.
• Read Community – Default is public.
• Write Community – Default is private. No changes are possible.
5. Click the Save button.
6. Click the Confirm button.
A snMP t s
dding An rAP ink
To add a trap sink:
1. Click the Administration tab.
2. Click the Services icon.
3. Click SNMP service and click the Settings button.
4. Enter a trap sink server IP address in the field provided.
5. Choose a trap filter (event severity level).
See the table on the next page.
6. Click the Add button.
7. Click the Confirm button.
DS300f G2 Series User Manual