Asus DS300j G2 Series User Manual page 230

Synchronization is completed
Synchronization is paused
Synchronization is resumed
Synchronization is stopped
Synchronization is aborted due to an internal
error.
Synchronization is queued
Synchronization is stopped internally
Subsystem ( ASUS DS300f G2 )
The Subsystem is started
The Subsystem is stopped
Subsystem parameter(s) are changed by user
System is set to Redundant mode
System is set to Critical mode
Enclosure has only N PSU left
Enclosure has only N-1 PSU left
System is set to Non-Redundant mode
Transition
Transition is started
Transition is completed
Transition is paused
Transition is resumed
Transition is stopped
Transition was switched to rebuild
Unknown
Unknown priority reason is detected
Zoning
Zoning permission settings with the expander
has been reset to defaults
Zoning expander has been rebooted.
Zoning permission settings with the expander
different than expected
224
No action is required.
Resume synchronization when ready.
No action is required.
Reduce system load on the ASUS DS300f G2.
No action is required.
No action is required.
Check controller operation.
Check to make sure each enclosure has three or more
operational PSU. (N=2 for ASUS DS300f G2 and
DS300j G2 models)
If your system has two controllers, check controller
operation.
No action is required.
Resume transition when ready.
No action is required.
If this action was not intentional, check the disk array's
status.
Replace the dead physical drive or reinstall the missing
drive.
If this message appears repeatedly, contact Tech
Support.
No action is required.
Settings have been updated correctly. No action is
required.
DS300f G2 Series User Manual