Asus DS300j G2 Series User Manual page 188

r o c
emovInG the lD ontroller
To remove the RAID controller:
1. Shutdown the ASUS DS300f G2.
2. Disconnect all attached cables from the RAID controller,
• Fibre Channel cables •
• iSCSI cables •
• SAS expansion cables •
3. On the controller handle, squeeze the release tab and pull the handle outward. See RAID controller release
handle and pull out, RAID controller release handle and pull out
4. Pull the RAID controller out of the subsystem enclosure.
I n c
nStallInG the ew ontroller
To install the new RAID controller:
1. Carefully slide the RAID controller into the enclosure.
2. Gently swing the handle in and press the handle until it locks.
3. Reconnect all cables that were attached to the RAID controller.
• Fibre Channel cables • Management port cables
• iSCSI cables • Serial cable
• SAS expansion cables • UPS control cable
4. Press the power power.
The ASUS DS300f G2 restarts.
5. Log into the ASUS DS300f G2.
182
Management port cables
Serial cable
UPS control cable
DS300f G2 Series User Manual