Iewing Ups I Nformation; Onnections; Ort S Ettings; Managing Network Connections - Asus DS300j G2 Series User Manual

v uPS I
IewInG nformatIon
To view information about a specific UPS unit:
1. Click the Device tab.
2. Click the UPS icon.
3. Mouse-over UPS and click the View button.
UPS information includes:
• UPS ID
• Model Name
• Serial Number
• Firmware Version
• Manufacture Date
• Voltage Rating – Output voltage of the UPS.
• Battery Capacity – Backup capacity expressed as a percentage.
• Remaining Backup Time – Number of minutes the UPS is expected
to power your system in the event of a power failure.
• Loading Ratio – Actual output of UPS as a percentage of the rated output. See the Note below.
• Temperature – Reported temperature of the UPS unit.
Note
The maximum recommended Loading Ratio varies among models of UPS units. The general range
is 60% to 80%. If the reported Loading Ratio exceeds the recommended value for your UPS unit:
Have fewer subsystems or peripherals connected to this UPS unit.
Add more UPS units, or use a higher-capacity UPS unit, to protect your RAID systems.
68
M n C
anaGInG etwork
Network Connections Management includes the following functions:
• "Making Virtual Management Port Settings" on page 68
• "Making Maintenance Mode Settings" on page 69
m v m P
akInG Irtual anaGement ort
The ASUS DS300f G2 subsystem has a virtual management port, enabling you to log into a ASUS DS300f G2
with dual controllers using one IP address.
Before you change settings, please see "About IP Addresses" on page 36.
You initially made these settings during subsystem setup. You can change them later as required.
Caution
Changing virtual management port settings can interrupt your ASUS Storage Man-
agement connection and require you to log in again.
To make virtual management port settings:
1. Click the Administration tab.
2. Click the Network Management icon.
3. Click the Virtual Management Port tab.
4. Click the protocol family whose settings you want to change and click the Configuration button.
5. Make the following settings are needed:
• Check the Enable box to enable this protocol family.
• Check the Enable DHCP box to enable a DHCP server to make your
network settings. DHCP is currently supported in IPv4 only.
• For manual network settings, type the RAID subsystem's IP address, subnet mask,
gateway IP address, and DNS server IP address into the fields provided.
6. Click the Submit button.
DS300f G2 Series User Manual

onneCtIons

S
ettInGS