Managing The Subsystem (Clu) - Asus DS300j G2 Series User Manual

M s
anaGInG the ubsysteM
Subsystem Management includes the following functions:
• "Making Subsystem Settings (CLU)" on page 122
• "Locking or Unlocking the Subsystem (CLU)" on page 122
• "Setting Subsystem Date and Time (CLU)" on page 123
• "Making NTP Settings (CLU)" on page 123
• "Synchronizing with a NTP Server (CLU)" on page 123
m S S (clu)
akInG ubSyStem ettInGS
An alias is optional. To set an Alias for this subsystem:
1. From the Main Menu, highlight Subsystem Management and press Enter .
2. Highlight Subsystem Settings and press Enter .
3. Make changes as required:
• Type and alias into the Alias field.
Maximum of 48 characters. Use letters, numbers, space between words and underscore.
• Highlight Redundancy Type and press the spacebar to toggle
between Active-Active and Active-Standby.
Active-Active – Both RAID controllers are active and can share the load
Active-Standby – One RAID controller is in standby mode and goes active if the other fails
• Highlight Cache Mirroring and press the spacebar to toggle between Enabled and Disabled.
4. Press Control-A to save your settings.
122
(Clu)
r m P (clu)
unnInG eDIa atrol
Media Patrol is a routine maintenance procedure that checks the magnetic media on each disk drive. Media
Patrol checks all physical drives assigned to disk arrays and spare drives. It does not check unconfigured drives.
To start, stop, pause or resume Media Patrol:
1. From the Main Menu, highlight Subsystem Management and press Enter .
2. Highlight Media Patrol and press Enter .
3. Highlight Start , Stop , Pause , or Resume and press Enter .
4. If you chose Stop , press Y to confirm.
l u S
ockInG or nlockInG the ubSyStem
The lock prevents other sessions (including sessions with the same user) from making a configuration change
to the controller until the lock expires or a forced unlock is done. When the user who locked the controller logs
out, the lock is automatically released.
s l
etting the ock
To set the lock:
1. From the Main Menu, highlight Subsystem Management and press Enter .
2. Highlight Lock Management and press Enter .
3. In the Lock Time field, type a lock time in minutes.
1440 minutes = 24 hours
4. Highlight Lock and press Enter .
r l
esetting the ock
To reset the lock with a new time:
1. From the Main Menu, highlight Subsystem Management and press Enter .
2. Highlight Lock Management and press Enter .
3. In the Lock Time field, type a lock time in minutes.
1 to 1440 minutes (24 hours)
4. Highlight Renew and press Enter .
DS300f G2 Series User Manual
(clu)